Surface treatment on cobalt and titanium alloys using picosecond laser pulses in burst mode

The authors report on the results of surface treatment experiments using a solid-state amplified laser source emitting laser pulses with a pulse duration of 10 ps. The laser source allows the generation of pulse trains (bursts) with an intra-burst pulse repetition rate of 80 MHz (pulse-to-pulse time interval about 12.5 ns) with up to eight pulses per burst. In this study a wavelength of 1064 nm was used to investigate both ablation of material and laser-induced surface modifications occuring in metallic implant alloys CoCrMo (cobalt-chromium-molybdenum) and TiAlV (titanium-aluminum-vanadium) in dependence of the number of pulses and fluences per pulse in the burst. By using the burst mode, a smoothing effect occurs in a certain parameter range, resulting in very low surface roughness of the generated microstructures. It is demonstrated that at fluences per pulse which are smaller than the material-specific ablation threshold, a self-organized pore formation takes place if a defined number of pulses per burst is used. Thus, the advantage of the MHz burst mode in terms of a possible surface modification is established.

VIVO@HSMW